[PATCH 07/10] staging: most: usb: replace code to calculate array index
Christian Gromm
christian.gromm at microchip.com
Wed May 27 09:06:24 UTC 2020
This patch removes the expression that makes use of a priori knowledge
about channel numbers to calculate an array index.
The expression 'peer = 1 - channel' utilizes the fact that an USB interface
that operates on the asynchronous data of the Network only has two
endpoints. Hence, channel being 0 or 1. The replacement is more simple and
less confusing when reading the code.
Signed-off-by: Christian Gromm <christian.gromm at microchip.com>
Reported-by: Dan Carpenter <dan.carpenter at oracle.com>
---
drivers/staging/most/usb/usb.c | 11 ++++++++---
1 file changed, 8 insertions(+), 3 deletions(-)
diff --git a/drivers/staging/most/usb/usb.c b/drivers/staging/most/usb/usb.c
index 03318de..468aabf 100644
--- a/drivers/staging/most/usb/usb.c
+++ b/drivers/staging/most/usb/usb.c
@@ -729,6 +729,8 @@ static void wq_clear_halt(struct work_struct *wq_obj)
struct most_dev *mdev = clear_work->mdev;
unsigned int channel = clear_work->channel;
int pipe = clear_work->pipe;
+ int snd_pipe;
+ int peer;
mutex_lock(&mdev->io_mutex);
most_stop_enqueue(&mdev->iface, channel);
@@ -746,9 +748,12 @@ static void wq_clear_halt(struct work_struct *wq_obj)
*/
if (mdev->conf[channel].data_type == MOST_CH_ASYNC &&
mdev->conf[channel].direction == MOST_CH_RX) {
- int peer = 1 - channel;
- int snd_pipe = usb_sndbulkpipe(mdev->usb_device,
- mdev->ep_address[peer]);
+ if (channel == 0)
+ peer = 1;
+ else
+ peer = 0;
+ snd_pipe = usb_sndbulkpipe(mdev->usb_device,
+ mdev->ep_address[peer]);
usb_clear_halt(mdev->usb_device, snd_pipe);
}
mdev->is_channel_healthy[channel] = true;
--
2.7.4
More information about the devel
mailing list