[PATCH v1 0/3] Tegra GPIO: Minor code clean up

[Bartosz Golaszewski]

wt., 7 sty 2020 o 10:29 Linus Walleij <linus.walleij at linaro.org> napisał(a):
>
> On Tue, Jan 7, 2020 at 9:25 AM Bartosz Golaszewski
> <bgolaszewski at baylibre.com> wrote:
>
> > pon., 6 sty 2020 o 23:59 Linus Walleij <linus.walleij at linaro.org> napisał(a):
> > > On Sun, Dec 15, 2019 at 7:31 PM Dmitry Osipenko <digetx at gmail.com> wrote:
> > >
> > > > I was investigating why CPU hangs during of GPIO driver suspend and in
> > > > the end it turned out that it is a Broadcom WiFi driver problem because
> > > > it keeps OOB wake-interrupt enabled while WLAN interface is DOWN and this
> > > > may cause a bit weird CPU hang on writing to INT_ENB register during of
> > > > GPIO driver suspend. Meanwhile I also noticed that a few things could be
> > > > improved in the driver, that's what this small series addresses.
> > > >
> > > > Dmitry Osipenko (3):
> > > >   gpio: tegra: Use generic readl_relaxed/writel_relaxed accessors
> > > >   gpio: tegra: Properly handle irq_set_irq_wake() error
> > > >   gpio: tegra: Use NOIRQ phase for suspend/resume
> > >
> > > All three patches applied with Thierry's review/test tag.
> > >
> > > Yours,
> > > Linus Walleij
> >
> > Ugh, I now noticed I responded to Thierry only after applying this to my tree.
> >
> > Anyway, it shouldn't be a problem. I'll take more care next time.
>
> OK shall I drop the patches from my tree then? No big deal.
>

If you're fine with this, sure!

Thanks a lot,
Bart