[PATCH 2/2] staging: wilc1000: avoid twice IRQ handler execution for each single interrupt

[Ajay.Kathat at microchip.com]

From: Ajay Singh <ajay.kathat at microchip.com>

The IRQ handler(isr_bh_routine()) was called twice for each interrupt
from firmware. The data was read completely during the first call and
the second call was doing nothing.
Now changed the IRQ flag from ‘level’ to ‘edge’ trigger i.e
IRQF_TRIGGER_LOW to IRQF_TRIGGER_FALLING to avoid extra interrupt
trigger.

Signed-off-by: Ajay Singh <ajay.kathat at microchip.com>
---
 drivers/staging/wilc1000/wilc_netdev.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/staging/wilc1000/wilc_netdev.c b/drivers/staging/wilc1000/wilc_netdev.c
index cd11c35adcfe..508acb8bb089 100644
--- a/drivers/staging/wilc1000/wilc_netdev.c
+++ b/drivers/staging/wilc1000/wilc_netdev.c
@@ -60,7 +60,7 @@ static int init_irq(struct net_device *dev)
 
 	ret = request_threaded_irq(wl->dev_irq_num, isr_uh_routine,
 				   isr_bh_routine,
-				   IRQF_TRIGGER_LOW | IRQF_ONESHOT,
+				   IRQF_TRIGGER_FALLING | IRQF_ONESHOT,
 				   "WILC_IRQ", dev);
 	if (ret < 0)
 		netdev_err(dev, "Failed to request IRQ\n");
-- 
2.22.0