[PATCH 1/4] staging: wilc1000: use runtime configuration for sdio oob interrupt
Julian Calaby
julian.calaby at gmail.com
Mon Nov 25 09:26:55 UTC 2019
Hi Adham,
On Sat, Nov 23, 2019 at 7:55 AM <Adham.Abozaeid at microchip.com> wrote:
>
> From: Ajay Singh <ajay.kathat at microchip.com>
>
> Set SDIO Out-of-band interrupt configuration at run time by passing
> parameter during module load.
The OOB interrupt is a GPIO and this is an SDIO card, so why not just
set the relevant pin in the devicetree and detect it based on that?
I'm pretty sure that the Broadcom fmac driver does something like this.
Thanks,
--
Julian Calaby
Email: julian.calaby at gmail.com
Profile: http://www.google.com/profiles/julian.calaby/
More information about the devel
mailing list