[PATCH 3/3] Documentation: devicetree: bindings: Add DT binding doc for xm2mvsc driver

Rohit Athavale rohit.athavale at xilinx.com
Wed Feb 21 02:40:35 UTC 2018


This commit adds the binding doc for the DT that the driver expects.
Driver has been tested against Zynq US+ board.

Signed-off-by: Rohit Athavale <rohit.athavale at xilinx.com>
---
 .../devicetree/bindings/xm2mvscaler.txt            | 25 ++++++++++++++++++++++
 1 file changed, 25 insertions(+)
 create mode 100644 drivers/staging/xm2mvscale/Documentation/devicetree/bindings/xm2mvscaler.txt

diff --git a/drivers/staging/xm2mvscale/Documentation/devicetree/bindings/xm2mvscaler.txt b/drivers/staging/xm2mvscale/Documentation/devicetree/bindings/xm2mvscaler.txt
new file mode 100644
index 0000000..1f3d805
--- /dev/null
+++ b/drivers/staging/xm2mvscale/Documentation/devicetree/bindings/xm2mvscaler.txt
@@ -0,0 +1,25 @@
+Xilinx M2M Video Scaler
+-----------------------
+This document describes the DT bindings required by the
+Xilinx M2M Video Scaler driver.
+
+Required Properties:
+- compatible           : Must be "xlnx,v-m2m-scaler"
+- reg                  : Memory map for module access
+- reset-gpios          : Should contain GPIO reset phandle
+- interrupt-parent     : Interrupt controller the interrupt is routed through
+- interrupts           : Should contain DMA channel interrupt
+- xlnx,scaler-num-taps : The number of filter taps for scaling filter
+- xlnx,scaler-max-chan : The maximum number of supported scaling channels
+
+Examples
+---------
+       v_multi_scaler: v_multi_scaler at a0000000 {
+               compatible = "xlnx,v-m2m-scaler";
+               reg = <0x0 0xa0000000 0x0 0x10000>;
+               reset-gpios = <&gpio 78 1>;
+               interrupt-parent = <&gic>;
+               interrupts = <0 89 4>;
+               xlnx,scaler-num-taps = <6>;
+               xlnx,scaler-max-chan = <4>;
+       };
--
1.9.1

This email and any attachments are intended for the sole use of the named recipient(s) and contain(s) confidential information that may be proprietary, privileged or copyrighted under applicable law. If you are not the intended recipient, do not read, copy, or forward this email message or any attachments. Delete this email message and any attachments immediately.


More information about the devel mailing list