[PATCH v3 3/3] staging: greybus: arche-platform: Switch to the gpio descriptor interface
Nishad Kamdar
nishadkamdar at gmail.com
Sat Dec 22 14:42:52 UTC 2018
On Tue, Dec 18, 2018 at 12:50:56PM +0100, Johan Hovold wrote:
> On Thu, Nov 22, 2018 at 10:39:24PM +0530, Nishad Kamdar wrote:
> > Use the gpiod interface instead of the deprecated
> > old non-descriptor interface.
> >
> > Signed-off-by: Nishad Kamdar <nishadkamdar at gmail.com>
> > ---
> > Changes in v2:
> > - Move comment to the same line as to what it applies to.
> > ---
> > drivers/staging/greybus/arche-platform.c | 119 ++++++++---------------
> > 1 file changed, 41 insertions(+), 78 deletions(-)
> >
> > diff --git a/drivers/staging/greybus/arche-platform.c b/drivers/staging/greybus/arche-platform.c
> > index 4c36e88766e7..a5cea79d8e32 100644
> > --- a/drivers/staging/greybus/arche-platform.c
> > +++ b/drivers/staging/greybus/arche-platform.c
> > @@ -8,10 +8,9 @@
> >
> > #include <linux/clk.h>
> > #include <linux/delay.h>
> > -#include <linux/gpio.h>
> > +#include <linux/gpio/consumer.h>
> > #include <linux/init.h>
> > #include <linux/module.h>
> > -#include <linux/of_gpio.h>
> > #include <linux/of_platform.h>
> > #include <linux/pinctrl/consumer.h>
> > #include <linux/platform_device.h>
> > @@ -45,14 +44,14 @@ enum svc_wakedetect_state {
> >
> > struct arche_platform_drvdata {
> > /* Control GPIO signals to and from AP <=> SVC */
> > - int svc_reset_gpio;
> > + struct gpio_desc *svc_reset;
> > + struct gpio_desc *svc_sysboot;
>
> Why move sysboot? The flag below is about reset (but should eventually
> go away).
>
Ok, I'll restore its position.
> > bool is_reset_act_hi;
> > - int svc_sysboot_gpio;
> > - int wake_detect_gpio; /* bi-dir,maps to WAKE_MOD & WAKE_FRAME signals */
> > + struct gpio_desc *wake_detect; /* bi-dir,maps to WAKE_MOD & WAKE_FRAME signals */
> >
> > enum arche_platform_state state;
> >
> > - int svc_refclk_req;
> > + struct gpio_desc *svc_refclk_req;
> > struct clk *svc_ref_clk;
> >
> > struct pinctrl *pinctrl;
> > @@ -85,9 +84,9 @@ static void arche_platform_set_wake_detect_state(
> > arche_pdata->wake_detect_state = state;
> > }
> >
> > -static inline void svc_reset_onoff(unsigned int gpio, bool onoff)
> > +static inline void svc_reset_onoff(struct gpio_desc *gpio, bool onoff)
> > {
> > - gpio_set_value(gpio, onoff);
> > + gpiod_set_value(gpio, onoff);
> > }
> >
> > static int apb_cold_boot(struct device *dev, void *data)
> > @@ -116,7 +115,6 @@ static int apb_poweroff(struct device *dev, void *data)
> > static void arche_platform_wd_irq_en(struct arche_platform_drvdata *arche_pdata)
> > {
> > /* Enable interrupt here, to read event back from SVC */
> > - gpio_direction_input(arche_pdata->wake_detect_gpio);
> > enable_irq(arche_pdata->wake_detect_irq);
> > }
> >
> > @@ -160,7 +158,7 @@ static irqreturn_t arche_platform_wd_irq(int irq, void *devid)
> >
> > spin_lock_irqsave(&arche_pdata->wake_lock, flags);
> >
> > - if (gpio_get_value(arche_pdata->wake_detect_gpio)) {
> > + if (gpiod_get_value(arche_pdata->wake_detect)) {
> > /* wake/detect rising */
> >
> > /*
> > @@ -224,10 +222,10 @@ arche_platform_coldboot_seq(struct arche_platform_drvdata *arche_pdata)
> >
> > dev_info(arche_pdata->dev, "Booting from cold boot state\n");
> >
> > - svc_reset_onoff(arche_pdata->svc_reset_gpio,
> > + svc_reset_onoff(arche_pdata->svc_reset,
>
> No need to break line here.
>
Ok.
> > arche_pdata->is_reset_act_hi);
> >
> > - gpio_set_value(arche_pdata->svc_sysboot_gpio, 0);
> > + gpiod_set_value(arche_pdata->svc_sysboot, 0);
> > usleep_range(100, 200);
> >
> > ret = clk_prepare_enable(arche_pdata->svc_ref_clk);
> > @@ -238,7 +236,7 @@ arche_platform_coldboot_seq(struct arche_platform_drvdata *arche_pdata)
> > }
> >
> > /* bring SVC out of reset */
> > - svc_reset_onoff(arche_pdata->svc_reset_gpio,
> > + svc_reset_onoff(arche_pdata->svc_reset,
>
> Same here. Please check throughout.
>
Yes.
> > !arche_pdata->is_reset_act_hi);
> >
> > arche_platform_set_state(arche_pdata, ARCHE_PLATFORM_STATE_ACTIVE);
> > @@ -259,10 +257,10 @@ arche_platform_fw_flashing_seq(struct arche_platform_drvdata *arche_pdata)
> >
> > dev_info(arche_pdata->dev, "Switching to FW flashing state\n");
> >
> > - svc_reset_onoff(arche_pdata->svc_reset_gpio,
> > + svc_reset_onoff(arche_pdata->svc_reset,
> > arche_pdata->is_reset_act_hi);
> >
> > - gpio_set_value(arche_pdata->svc_sysboot_gpio, 1);
> > + gpiod_set_value(arche_pdata->svc_sysboot, 1);
> >
> > usleep_range(100, 200);
> >
> > @@ -273,7 +271,7 @@ arche_platform_fw_flashing_seq(struct arche_platform_drvdata *arche_pdata)
> > return ret;
> > }
> >
> > - svc_reset_onoff(arche_pdata->svc_reset_gpio,
> > + svc_reset_onoff(arche_pdata->svc_reset,
> > !arche_pdata->is_reset_act_hi);
> >
> > arche_platform_set_state(arche_pdata, ARCHE_PLATFORM_STATE_FW_FLASHING);
> > @@ -305,7 +303,7 @@ arche_platform_poweroff_seq(struct arche_platform_drvdata *arche_pdata)
> > clk_disable_unprepare(arche_pdata->svc_ref_clk);
> >
> > /* As part of exit, put APB back in reset state */
> > - svc_reset_onoff(arche_pdata->svc_reset_gpio,
> > + svc_reset_onoff(arche_pdata->svc_reset,
> > arche_pdata->is_reset_act_hi);
> >
> > arche_platform_set_state(arche_pdata, ARCHE_PLATFORM_STATE_OFF);
> > @@ -435,6 +433,7 @@ static int arche_platform_probe(struct platform_device *pdev)
> > struct device *dev = &pdev->dev;
> > struct device_node *np = dev->of_node;
> > int ret;
> > + unsigned int flags;
> >
> > arche_pdata = devm_kzalloc(&pdev->dev, sizeof(*arche_pdata),
> > GFP_KERNEL);
> > @@ -444,61 +443,33 @@ static int arche_platform_probe(struct platform_device *pdev)
> > /* setup svc reset gpio */
> > arche_pdata->is_reset_act_hi = of_property_read_bool(np,
> > "svc,reset-active-high");
>
> This should also go away eventually in favour of gpio flags in
> devicetree. Fine to keep for now, though.
>
Ok.
> > - arche_pdata->svc_reset_gpio = of_get_named_gpio(np,
> > - "svc,reset-gpio",
> > - 0);
> > - if (!gpio_is_valid(arche_pdata->svc_reset_gpio)) {
> > - dev_err(dev, "failed to get reset-gpio\n");
> > - return arche_pdata->svc_reset_gpio;
> > - }
> > - ret = devm_gpio_request(dev, arche_pdata->svc_reset_gpio, "svc-reset");
> > - if (ret) {
> > - dev_err(dev, "failed to request svc-reset gpio:%d\n", ret);
> > - return ret;
> > - }
> > - ret = gpio_direction_output(arche_pdata->svc_reset_gpio,
> > - arche_pdata->is_reset_act_hi);
> > - if (ret) {
> > - dev_err(dev, "failed to set svc-reset gpio dir:%d\n", ret);
> > + if (arche_pdata->is_reset_act_hi)
> > + flags = GPIOD_OUT_HIGH;
> > + else
> > + flags = GPIOD_OUT_LOW;
> > +
> > + arche_pdata->svc_reset = devm_gpiod_get(dev, "svc,reset-gpio", flags);
> > + if (IS_ERR(arche_pdata->svc_reset)) {
> > + ret = PTR_ERR(arche_pdata->svc_reset);
> > + dev_err(dev, "failed to request svc-reset GPIO:%d\n", ret);
> > return ret;
> > }
>
> Thanks,
> Johan
Thanks for the review.
Regards,
Nishad
More information about the devel
mailing list