[PATCH] staging: wilc1000: Set all options in region debugfs file

[Greg KH]

On Wed, Aug 19, 2015 at 06:00:12PM +0530, Chandra Gorentla wrote:
> On Tue, Aug 18, 2015 at 08:01:00PM -0700, Greg KH wrote:
> > On Tue, Aug 18, 2015 at 10:32:17PM +0530, Chandra S Gorentla wrote:
> > > This patch allows setting all options in the module's debug region
> > > options file 'wilc_debug_region'.  This functionality allows the user
> > > to enable logging from all regions (initialization, locks, firmware
> > > etc.) of the driver.  Logging from the following regions is enabled
> > > during the driver initialization:
> > > 
> > > INIT_DBG, GENERIC_DBG, CFG80211_DBG, FIRM_DBG and HOSTAPD_DBG
> > > 
> > > Before this change, the numerical value set is equal first byte of 
> > > input minus 0x30 (ASCII value of '0').  Because of this, after a write 
> > > to this debugfs file, it is difficult to predict the regions on which
> > > logging is enabled.
> > > 
> > > The DBG_REGION_ALL now includes 3 additional regions TCP_ENH, SPIN_DEBUG
> > > and FIRM_DBG.
> > 
> > Why did you add these extra ones?
> I added them because there is code support them and to avoid a holes in
> the range of the options.

But why do you need to debug such things?

> > All of this should eventually just be deleted, as network drivers need
> > to use the networking driver debug interfaces, not their own crazy ones.
> In that case, can I assume that we are not going forward with this change?

I hope not, please work on fixing the driver up to work properly (i.e.
not with this type of stuff...)

thanks,

greg k-h