[PATCH RFC 27/46] imx-drm: convert to componentised device support

[Eric Nelson]

Hi Philipp,

On 01/03/2014 10:26 AM, Philipp Zabel wrote:
> Am Freitag, den 03.01.2014, 17:07 +0000 schrieb Russell King - ARM
> Linux:
>> On Fri, Jan 03, 2014 at 05:48:57PM +0100, Philipp Zabel wrote:
>>> Hi Russell,
>>>
>>> I've tested this series on a BD-SL (SabreLite) with HDMI. Right now
>>> the HPD signal doesn't seem to work, but after overwriting the
>>> connection check, I got a stable and correct picture on the monitor:
>>
>> Hmm.  Does this mean you're not getting any IRQs from the HDMI interface
>> when you plug and unplug the monitor?
>>
>> 147:        281       GIC 147  120000.hdmi
>>
>> on turning the TV on:
>>
>> 147:        282       GIC 147  120000.hdmi
>>
>> on unplugging the HDMI cable:
>>
>> 147:        283       GIC 147  120000.hdmi
>>
>> on replugging the HDMI cable:
>>
>> 147:        284       GIC 147  120000.hdmi
>
> Exactly. And while the RX_SENSE bits of HDMI_IH_PHY_STAT0 change when I
> (un)plug, the HPD bit stays zero. I'll check with other hardware.
>

This is an issue we've seen before. The SABRE Lite board has
a voltage divider on the HPD pins and some monitors (esp. DVI
monitors) either don't drive things high enough to assert HPD or
bounce with connect/disconnect.

We've instrumented our 3.0.35 kernels to use the RX_SENSE bits
instead.

Regards,


Eric