[PATCH] staging: r8188eu: default to "y" in Kconfig

[Paul Bolle]

Two Kconfig entries for this driver default to (uppercase) "Y". But in
Kconfig (lowercase) "y" is a magic symbol. "Y" is an ordinary symbol.
As "Y" is never set these Kconfig symbols will also not be set by
default.

So use "default y" here, as was clearly intended.

Signed-off-by: Paul Bolle <pebolle at tiscali.nl>
---
This patch will enable code that used to be disabled. Since this is in
staging, that should be OK. This might also uncover warnings or errors.
I didn't test it, anyhow.

This patch also deserves a
    Reported-by: Martin Walch <walch.martin at web.de>

line, but that apparently requires Martin's permission.

 drivers/staging/rtl8188eu/Kconfig | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/staging/rtl8188eu/Kconfig b/drivers/staging/rtl8188eu/Kconfig
index c9c548f..9a57d31 100644
--- a/drivers/staging/rtl8188eu/Kconfig
+++ b/drivers/staging/rtl8188eu/Kconfig
@@ -12,7 +12,7 @@ if R8188EU
 
 config 88EU_AP_MODE
 	bool "Realtek RTL8188EU AP mode"
-	default Y
+	default y
 	---help---
 	This option enables Access Point mode. Unless you know that your system
 	will never be used as an AP, or the target system has limited memory,
@@ -20,7 +20,7 @@ config 88EU_AP_MODE
 
 config 88EU_P2P
 	bool "Realtek RTL8188EU Peer-to-peer mode"
-	default Y
+	default y
 	---help---
 	This option enables peer-to-peer mode for the r8188eu driver. Unless you
 	know that peer-to-peer (P2P) mode will never be used, or the target system has
-- 
1.8.5.3