[kconfig] update: results of some syntactical checks

[Paul Bolle]

On Sun, 2013-10-20 at 00:03 +0200, Martin Walch wrote:
> drivers/media/common/siano/Kconfig:21-26
> > config SMS_SIANO_DEBUGFS
> >	bool "Enable debugfs for smsdvb"
> >	depends on SMS_SIANO_MDTV
> >	depends on DEBUG_FS
> >	depends on SMS_USB_DRV
> >	depends on CONFIG_SMS_USB_DRV = CONFIG_SMS_SDIO_DRV
> 
> The last line adds the dependency CONFIG_SMS_USB_DRV = CONFIG_SMS_SDIO_DRV.
> This expression does not look sound as those two symbols are not declared
> anywhere. So, the two strings CONFIG_SMS_USB_DRV and CONFIG_SMS_SDIO_DRV
> are compared, yielding always 'n'. As a result, SMS_SIANO_DEBUGFS will never
> be enabled.

Those are obvious typos. Still present in v3.12-rc7. Perhaps you'd like
to send the trivial patch to fix this?

> Probably, it was meant to say something like
> >	depends on SMS_USB_DRV = SMS_SDIO_DRV
> 
> Two other config sections that probably behave differently than expected:
> 
> drivers/staging/rtl8188eu/Kconfig: 13-15
> > config 88EU_AP_MODE
> >	bool "Realtek RTL8188EU AP mode"
> >	default Y
> 
> drivers/staging/rtl8188eu/Kconfig: 21-23
> > config 88EU_P2P
> >	bool "Realtek RTL8188EU Peer-to-peer mode"
> >	default Y
> 
> The capital Y is different from the lowercase y. While y is an actually
> hard coded constant symbol, Y is undeclared and evaluates to n.
> The default values are probably only for convenience, so 88EU_AP_MODE and
> 88EU_P2P are activated together with 8188EU. They still can be turned off.
> Anyway, it should probably say "default y" in both cases.

Ditto. 


Paul Bolle