[PATCH 08/20] Staging: ipack: Switch to 8MHz operation before reading ID.

[Samuel Iglesias Gonsálvez]

From: Jens Taprogge <jens.taprogge at taprogge.org>

Reading the ID space at 8 MHz is always supported.  Most carriers will
boot up in 8MHz mode.  Still, play it safe and ensure we are operating at
8Mhz.

Signed-off-by: Jens Taprogge <jens.taprogge at taprogge.org>
Signed-off-by: Samuel Iglesias Gonsálvez <siglesias at igalia.com>
---
 drivers/staging/ipack/ipack.c |   11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/drivers/staging/ipack/ipack.c b/drivers/staging/ipack/ipack.c
index 4f3c945..95f56b8 100644
--- a/drivers/staging/ipack/ipack.c
+++ b/drivers/staging/ipack/ipack.c
@@ -376,6 +376,9 @@ struct ipack_device *ipack_device_register(struct ipack_bus_device *bus,
 	dev_set_name(&dev->dev,
 		     "ipack-dev.%u.%u", dev->bus_nr, dev->slot);
 
+	if (bus->ops->set_clockrate(dev, 8))
+		dev_warn(&dev->dev, "failed to switch to 8 MHz operation for reading of device ID.\n");
+
 	ret = ipack_device_read_id(dev);
 	if (ret < 0) {
 		dev_err(&dev->dev, "error reading device id section.\n");
@@ -384,9 +387,11 @@ struct ipack_device *ipack_device_register(struct ipack_bus_device *bus,
 	}
 
 	/* if the device supports 32 MHz operation, use it. */
-	ret = bus->ops->set_clockrate(dev, dev->speed_32mhz ? 32 : 8);
-	if (ret < 0)
-		dev_err(&dev->dev, "failed to switch to 32 MHz operation.\n");
+	if (dev->speed_32mhz) {
+		ret = bus->ops->set_clockrate(dev, 32);
+		if (ret < 0)
+			dev_err(&dev->dev, "failed to switch to 32 MHz operation.\n");
+	}
 
 	ret = device_register(&dev->dev);
 	if (ret < 0) {
-- 
1.7.10.4