ARM IOMUX GPIO SETTING
Greg KH
greg at kroah.com
Wed May 12 19:47:35 UTC 2010
On Wed, May 12, 2010 at 10:25:22AM +0530, snehajp wrote:
> Hi ,
>
> We are using i.mx 25 board which consists of arm9 controller.I need to
> convert the CMOS connector in the board to parallel port pins.We have to
> convert CMOS connector pins to GPIO pins using IOMUX configuration.Could
> any one help me to configure GPIO pins as parallel port pins and to set
> the base address.
Try asking this on the arm linux mailing list, that's the best place to
find people to help out with this.
good luck,
greg k-h
More information about the devel
mailing list